Epec 4602 Control Unit

Epec 4602控制器

Epec 4602 控制器配有多种可编程I/O接口,可用于执行不同任务。通过 20 个 PWM 输出和 10 个反馈引脚,Epec 4602控制器可同时控制 10 个液压模块。它既可作为独立控制器使用,也可用作分布式控制系统的组成部分。

控制器的光滑外壳可保护电子设备免受机械磨损。密封的铝/塑料外壳经过大量测试验证,可用于应对各类作业环境。控制器配有一个用于诊断的LED信号灯,还配有一个双引脚CAN总线,无需在线束中设置分支线路,方便布线。

Epec 4602 Control Unit has a wide range of programmable I/Os for different implementations. Epec 4602 can control 10 hydraulic blocks simultaneously by using 20 PWM outputs and 10 feedbacks. It can be used as a stand-alone controller or as part of decentralized control system.

The unit’s sleek shaped casing works to protect the electronics against mechanical wear. The leak-proof aluminum/plastic housing has also been widely tested against different environmental conditions. The unit is equipped with a signal LED for diagnostics. One CAN is also equipped with double pins to make cabling easier since there is no need for branches in the wire harness.

  • Processor: 16/32 bit CPU
  • Flash memory: 1,6 Mbyte
  • RAM: 138 kbyte
  • PLCopen application size: up to 768 kbyte
  • CAN: 2
  • I/O: 68 (44 inputs +24 outputs)
  • IP class: IP67
  • Temperature range: -40 … + 85 °C
    -40 … +185 °F
  • Connectors: 3 x AMP 35
  • CODESYS version: 2.3
  • Supported CAN protocols: CANopen, SAEJ1939
  • Two-colored diagnostic LED for quick status check and fault detection

Symbol / Name Explanation
CEThis product complies with the requirements set in the CE Standard.
E17This product is certified with normal automotive (E17) EMC (electromagnetic compatibility) standards.
RoHS2This product complies with the RoHS directive (The Restriction of the use of certain Hazardous Substances in Electrical and Electronic Equipment).
Ordering codeE30B4602-10
Technical ManualMAN000632
CAN2
5 V REF2
PWM / DO / DI
(sourcing 3 A)
16
PWM / DO / DI
(sourcing 4 A)
4
DI / DO GND4
FB / AI
(2 A)
10
DI/PI
(pull-up / pull-down selection, threshold voltage 3,1 V)
12
DI/PI
(pull-up / pull-down selection, threshold voltage 2,5 V)
1
DI/PI
(pull-up / pull-down selection, threshold voltage 1,25 V)
1
AI/DI
(0-37 V)
2
AI/DI
(0-5 V / 0-22 mA)
14
AI/DI
(0-5 V)
-
AI/DI
(0-5 V, pull-up to +5 V, pull-up resistance selection)
4

FINNISH KNOWLEDGE

tested, designed and produced in finland.

Epec control systems are made 100% in Finland. We are a control system expert, specializing in intelligent control systems and information systems for even the most demanding conditions. Epec’s organization and processes have been fine tuned to cooperate with large international customers.